Anti-theft smoke installation method (ceiling type)

1. Burglar-escaping smoke product installation 1.1 Anti-theft smoke evacuation installation location
The anti-theft smoke can be hung vertically on the wall, horizontally on the top, and the ceiling can be installed better.
Anti-theft alarm Please connect and install by professional technicians.
The control line from the controller to the anti-theft smoke evacuator has a minimum cross-sectional area of ​​0.5 mm 2 (in accordance with the national standard cable), and the cable clamp connects the jacket and the insulating material.
Anti-theft alarm Anti-theft smoke wall installation: It is recommended that the installation height not exceed 2.5 m, so as not to affect the effect of surface smoke coverage.
Anti-theft of smoke to install horizontally: The height of the installation from the ground should not exceed 3m, otherwise the smoke diffusion effect will be affected.
1.2 Installation Procedures for Anti-theft Smoke Detector
Follow the steps below to quickly install the anti-theft smoke evacuator.
(1) First check the load condition at the top of the room. If you find that the load-bearing capacity is poor, strengthen it first.
(2) Fix the bottom part of the main body of the anti-theft smoke detector and the top of the room, and fix it on the keel or other parts of the frame with screws to ensure that it will not fall off.
(3) Place the controller in a position that is easy to maintain. Make sure that the detector and the main body of the anti-theft alarm can be easily connected.
(4) When laying cables, pay attention to the use of trunking or conduits, or follow the user's requirements for the concealment of the wiring.
2. Appearance dimension drawing of anti-theft escaping smoke:
Anti-theft alarm
3. Anti-theft smoke connection diagram
Anti-theft alarm
Figure 1 baseplate mounting bracket
(1) Fix the bottom plate with four tapping screws to ensure firmness.
Anti-theft alarm
figure 2
(2) Snap the smoke device into the base plate and push it firmly into the slot.
Anti-theft alarm
image 3
(3) Connect the control cable of the anti-theft smoke detector with the terminal of the controller.
Anti-theft alarm
Figure 4
4. The work flow of anti-theft smoke grab
The command is issued by the alarm host or controller, the power circuit of Unicom, and the anti-theft alarm immediately activates to release a large amount of smoke.
5. The limitations of anti-theft smoke escaping
In the absence of power supply, the anti-theft device can not work and can not stop the violence.
The anti-theft device will activate all types of smoke detectors when spraying smoke, but it will not activate the thermal detector. Please check with local fire protection system administrators to avoid unnecessary losses.

Stellite tipped saws have shown to be able to:

 

•Increase run times.

 

•Cut with thinner kerf.

 

•Produce a smoother sawn surface.

 

•Reduce sawing variations - Better cutting accuracy. (allowing for tighter target sizes)

 

•Reduce the power consumption during cutting.

 

•Reduce the cutting downtime for saw changes and saw maintenance.

 

•Increased saw life due to the ability to achieve more sharpening and at longer intervals.

 

Stellite is also more resistant to the abrasive acids found in some woods like red cedar.

This allows the tips to stay sharp longer than carbide tips and significantly longer

than swaged saw steel when cutting unseasoned woods.

 

We have produced more than 100 kinds of specifications tips and export to Canada, USA,

France, New Zealand, Australia, Norway and Russia etc. more than 40 countries and areas.

 

Rectangle Saw Tips

Wood Bandsaw Blades,Rectangle Saw Tips,Rectangle Wood Bandsaw Blades,Cobalt Alloy Tip Saw

Shenyang New Industry Co.,LTD , https://www.topcobalt.com