Floor acceptance is an important link in the acceptance process of fully furnished rooms. Fully-furnished room wooden floor "common diseases" mainly include: color, drum, deformation, there is a deviation of height and when walking stampede, as well as blinking, cracks, scratches and so on. Home inspectors introduced: At present, the floor of the renovated house is more prominent.
Chun licensing floor    King of Arts wooden doors     Sanxiang floor
Acceptance of solid wood flooring first depends on whether the floor color is the same. If the color difference is too large, directly affect the appearance, you can ask for exchange; if the color is too consistent, almost no color, it depends on the floor surface pattern is the same. If the pattern is almost the same, it may be craft wood floor, not the material floor of the so-called precious wood species. Some floor material suppliers nowadays use ordinary wood material flooring, but in the surface of a veneer layer of valuable wood species to shoddy, and the reverse side with aluminum foil paste, said to be moisture-proof, in fact, is afraid of being seen negative The pattern is inconsistent with the front.
The second is to see whether the floor sounds, walk around on the floor during the acceptance, the footsteps must be increased, especially to rely on the wall area and the door hole should pay more attention, find the sound of the site, to walk around to determine the specific location of the sound, do Good mark. In this case, you can ask to remove the resurfacing. The site where there are sounds is caused by non-standard operations and unqualified materials used by construction workers during the construction process. The operation is not standardized, mainly reflected in the fixed keel is not solid; material failure is mainly reflected in the ground keel without drying. Some renovation construction units use undried keel construction. The surface shows signs of drying. In fact, they did not dry.
Sometimes we find that the floor is partially arched: if it is a solid wood floor, it is because it is too tight or the floor is too dry (water content is too low); if it is a laminate floor, it is a poor quality floor. Therefore, the arching of the floor is a serious quality problem.
Finally check the surface of the floor for defects such as blinks, crevices, and scratches. Commonly due to the untreated keel, there are locusts inside. When it was found that there was a blink, the floor was already almost cracked; gaps and scratches were known at a glance. Regulations: floor gap should not be greater than 0.5 mm; scratches are mainly caused by rough decoration, such as waxing method can not be repaired, it must be exchanged.
Construction acceptance nature floor del floor wooden door
Fenghua Jade Motor Co., Ltd. , http://www.nsoutdoorproducts.com