In order to maintain a good appearance and stable performance of the barrier, daily maintenance of the barrier is essential. So, what are the parking lot maintenance services? As a non-professional, how do you maintain it? Here we will give you an introduction.
External maintenance:
1. The cleaning and trimming of the gate bar, the bar above the bar will generally be covered with dust, managers should promptly clean up; In addition, if the reflective film of the brake bar off or degumming, should be repaired. This maintenance cycle is recommended once a month.
2, open the box to check the wire joints are tight, repair electrical contacts, check gear wear and limit switches should also check the fastening, check the maintenance cycle once a month.
3. Add lubricating oil to each rotating shaft and replenish the oil in the gearbox timely. If the capacitor has a spoiled oil leak, replace it immediately. This proposal is checked and maintained every month.
4. Keep the gate box clean and check whether the door and the box cover are sealed to prevent the entry of dust and rainwater. It is recommended to check and maintain it once a month.
Internal maintenance:
The movement is the heart of the machine and it must be maintained. It is recommended to maintain it once a month.
1. Cut off the power, open the cover of the brake, clean the surface dust, add the butter after cleaning the transmission part first, and apply some butter to the gear and wheel groove.
2. Check the fasteners and connecting rods for loosening and tighten them.
3. Check the wear of the wearing parts. The positioning arm and the positioning plate of the gate must be replaced with more than 3mm clearance. The normal clearance (1-1.5mm) should be properly added to the solenoid valve core to make the solenoid valve Reduce resistance during exercise and be lubricated. Be careful not to add too much. Be moderate.
4. Pay attention to the limit switch and the limit piece of the gate. Do not adjust it to prevent it from being too far or too close.
Note: The internal and external barriers should always pay attention to maintenance, a little bit of a problem, a long time will affect the use, so we must understand the importance of maintenance of the gate. The above-mentioned internal maintenance personnel must be professionally trained to fully understand the strengths and weaknesses before they can go on duty.
Eva Traction Pad is the tail pad to be sticked on the surfboard. It comes with center arch and kick tail, which allow surfers to control the direction and stability when surfing in the sea.
The design of surfboard Traction Pad can be in one piece, two pieces, or three pieces basically. The standard the classical texture for traction pad would be diamond like texture, as it can provide the stronger grip among all of them.
The EVA color connect logo is made along with the pad itself. Unlike the PVC logo, it is also EVA material same as pad, and also shows with the texture. The design of this logo can not be too detailed and small, it needs to be larger and simpler so that we can use the different color EVA material to connect them.
Eva Traction Pad,Non-Skip Traction Pad,Traction Pad,Surfboard Tail Pads,Grip Tail Pad,Eva Tail Pad
Huizhou Melors Plastic Products Factory , https://www.melorsfoam.com