Was it warm in the winter when it came to home?

The heating of individual household heating is much more than that of central heating, and the degree of freedom that consumers can control is much greater. It does not occupy indoor space, and it is also the reason why many people choose to warm. However, in the course of use, some wrong practices will damage the floor heating elements and affect the life of floor heating. Xiao Bian talks about the little knowledge he has to pay attention to.

First, the first time to start warming precautions

When first starting low-temperature hot water surface radiant heating (ie, water heating), follow the following procedures: First, pass water at 25-30°C to open the valve between the floor water supply pipe and the return pipe so that the return water enters the floor water supply pipe. In the road, after running for a week, the temperature of the water supply is increased by 5-10°C per week until the water supply temperature reaches 60-65°C.

When using water heating, the maximum water temperature of the system is 65°C, and it is recommended not to exceed 60°C. If the water supply temperature exceeds 60°C, the valve between the return water and the water supply should be opened so that the floor can be heated and returned to water for use. To adjust the room temperature, the temperature of the floor heating system and the amount of water entering the system should be adjusted based on the outdoor temperature. High outdoor temperatures can reduce the amount of water in the system and reduce the water supply temperature, and vice versa.

During the operation of the floor heating system, it is necessary to periodically check whether the filters, valves, thermometers, pressure gauges, etc. can be used normally. In view of the creep characteristics of the pipes due to the influence of temperature and pressure, during the heating period, there should be a dedicated person to put the water collector and the front end Valves and connecting parts shall be tightened several times and impurities in the filter shall be regularly cleaned. If any damage occurs, it shall be repaired and used again.

Second, check whether there is a drip before starting

Although developers or heating service providers have already experienced that the floor heating system is qualified at the time of acceptance of the house, the possible man-made damage during the renovation will still affect the normal operation of the floor heating system.

For households equipped with low-temperature hot water surface radiant heating (abbreviated as "water heating") system, before the first time running the water heating system, the pipeline system should be pressure tested to see if there is leakage or leakage. The reason why the pressure test was carried out was that the owner had inadvertently damaged the water heating system during the renovation.

To warm the brand warm

1 23 Next> Total 3 Pages
Page to page
Function assignPage() { var page = $('#page_val').val(); if (/_\d+\.html$/.test(location.href)) { location.href = location.href.replace( /_\d+\.html/, ((page == 1) && 1? '' : '_' + page) + '.html') } else if(/\/\d+\.html$/.test (location.href)) { location.href = location.href.replace(/(\d+)\.html/, ((page == 1) && 1? '$1' :'$1_' + page) + ' .html') } } $(function(){ $('#page_form').submit(function() { assignPage() return false; }) $('#page_btn').click(function(){ assignPage( ); return false; }) }) See full story

Melamine Particle Board is mainly used for furniture and carriage of bus, train.The bace&back are the Veneer surface, such as Okoume, Bintangor, Pine, Birch, Poplar, Pencil cedar, Maple, Cherry, White Oak, Sapele, Beech, Red Oak, Ash etc.Melamine paper is the most popular to be as the face board, it is abrasion resistant, heat resistant, fouling resistant, clean is simple.The Engineering wood is also as the face and back surface. It is more cheaper and beautiful, can reach the same wood grain effect as the veneer surface.And we have High Quality Particle Board .LULI Group Co. Ltd, well known as the leading manufacturer for wooden, steel and paper products, located in Shouguang, Weifang, Shandong, China. Since the foundation in 1985, it focus on the production of Plywood , venner, MDF, Particle board ,  Door skin , Blockboard , Finger joint board, OSB, paper, Steel etc.And we have Outdoor Melamine Particle Board.

Melamine Particle Board Details:

size:1220*2440MM 1250*2000MM 1525*2440MM 1830*2440MM

THICKNESS:9MM-40MM

MATERIAL:POPLAR, COMBINE, PINE

GLUE:E0, E1, E2

CERTIFICATION:CARB, FSC, CE

Melamine Particle Board

Melamine Particle Board,Melamine Faced Particle Board,Outdoor Melamine Particle Board,Melamine Laminated Particle Board

Luli Group Co.,Ltd. , https://www.plywoods.nl