Have you seen the state of the masons at work? The father of Xiaobian is a dedicated masons worker. In the past days, when he built a house in someone else's house, he would talk to me about some of these problems. Interior plastering technology is a must-have technology for masons. Next, Xiao Bian is very honored to take everyone to look at the relevant content of the interior wall plastering technology .
First, the drawing requirements
1, room, walkway, lobby, elevator shaft
The joint wall and the wall surface are connected with a nail width of 220mm steel mesh (diameter 0.9mm, mesh 12.7×12.7mm), uniform cement slurry (801 cement with 5% cement), 20mm thick 1:3 cement mortar Plastering, to achieve the standard of plastering, add anti-cracking fiber mesh, to achieve two-layer fortification, anti-cracking fiber mesh at the intersection of the outside of the wall surface, to achieve the effect of exposure.
2, bathroom
After the joint wall and the concrete floor joint, the nail width is 220mm steel mesh (diameter 0.9mm, mesh is 12.7×12.7mm), and the cement slurry (801 cement with 5% cement weight) is used. 20mm thick 1:3 cement mortar plaster finely brushed. Note: add floor drain to the bathroom.
3, stairwell
After the joint wall and the concrete floor joint, the nail width is 220mm steel mesh (diameter 0.9mm, mesh is 12.7×12.7mm), and the cement slurry (801 cement with 5% cement weight) is used. Layer 20mm thick rubber powder polystyrene particles, wipe 3~5mm polymer mortar, scrape ordinary putty twice, paint twice.
Second, the construction process
1. When hanging the wire mesh, try to make the wire mesh have a width of 110mm in two different materials. The wire mesh is fixed with nails on the brick wall. It should be fixed with special fixing equipment on the surface of the concrete. It is strictly forbidden to fix with nails.
2. The surface of the masonry should be cleaned before spraying, and the loose parts of the surface of the aerated concrete block should be removed.
3. Wet the masonry with a sprayer one day before the shotcrete.
4. Spray evenly with cement slurry mixed with interface agent.
5. After spraying, use a sprayer for at least one day before entering the plastering construction.
6. Before the plastering, find the square. According to the 20cm control line popped up by the technician on the ground, use the cement mortar to stick the gray cake on the wall surface. The thickness of the square to the plastering control line must be equal. Make sure the room is square.
7. Before the bottom layer is plastered, the steel bars must be removed to prevent the rust. The position of the cement bricks on the side of the door should be clearly indicated so that the door frame can be installed.
8. When the bottom ash is wiped, the underlying plaster should not be too thick, so that the sprayed cement slurry is just covered.
9. After the bottom layer is plastered for at least one day, the surface layer plastering can be carried out, and the gray surface layer of the plastering layer is required to be attached to the intersection of different wall materials, the slot of the pipeline, and the position of the flue.
The above content is a wonderful introduction to the interior wall plastering technology. I hope that every reader can be heard and applied in real life, and you will benefit a lot. Well, today's introduction to the interior wall plastering technology is here. Thanks to the readers for reading this article and for the support and love of Xiaobian. If you want more home improvement information, please continue. Pay attention to the decoration home network.
More related wonderful reading:
Interior wall plastering construction scheme
1.Fruit basket is a necessary product for families and hotel, also a good decoration decoration, improve your quality of life enjoy a more simple and comfortable high end quality of life.
2.China leading manufacturers and supplies of wire stainless steel product, specializing in the production of stainless steel wire fruit basket. Fruit basket, 2-tier fruit basket, steel wire fruit basket, stainless steel wire fruit basket, Creative Fruit Basket, Dry Fruit Basket, Modern fruit basket, steel wire Hollow Fruit Basket, Round fruit basket and so on.
3.Our factory has been established for 15 years , have a strong design business team and a strong production line can provide you with perfect service and the highest quality assurance.
Fruit basket,Vegetable basket,stainless steel fruit basket,Creative Fruit Basket,Modern fruit basket
Shenzhen Lanejoy Technology Co.,LTD , https://www.wire-spring.com