German Bosch Electric Safety Operating Procedures

Bosch BOSCH-GSH 27 hammer

I. Introduction of German Bosch Electric Co., Ltd.

Bosch Electric Co. has performed exceptionally well due to its high material removal rate. Vibration control gives it a longer running time and higher comfort. There is always a Bosch telegraph for you, even for heavy-duty demolition operations.

Second, the German Bosch electric advantages

1, a single high impact;

2, the structure is extremely strong, long service life;

3. The balanced hammer mechanism and vibration-reducing handle are used, so the vibrations are extremely low in the working state and no-load state.

Third, Germany Bosch features

1. Patented vibration control system;

2, pneumatic tools 1 1/8" can be used with the collar;

3, dust-proof chucks;

4, self-breaking carbon brush;

5. Interfaces that can be connected to any lamp holder, 16- amp fuse, and AC generator not exceeding 3 kVA;

6, used to break open the road, reinforced concrete ceiling, foundation, etc.;

7, can be used for mining hard materials, deposition of sand and other materials.

Fourth, the German Bosch electrician instructions

1. Please bring a hard hat (safety helmet), safety glasses and protective mask. It is also recommended to wear dust masks, ear protectors and thick pad gloves.

2. Before the operation, it must be confirmed that the chisel tip is fastened to the specified position.

3. During normal operation, this tool is designed to generate vibrations. As a result, the screws are easily loosened, resulting in breaks or accidents. Therefore, the screws must be carefully checked before the operation.

4, the cold season, or when the tool is not used for a long time, it should be allowed to operate under no load for several minutes to heat the tool.

5 , must be confirmed in a very strong place. When using the tool at a high place, it must be confirmed that no one is below.

6 , hold the tool with both hands

7 , can not touch the tool with your hand

8 , the tool can not be removed when the rotation. Only start the tool with your hand after picking up the tool.

9. During operation, the chisel tip should not refer to anyone present. Punishment of personal injury due to possible flyout

10. When chiseling chisel into the wall, floor or any place where there may be buried wire, never touch the metal part of the tool, hold the tool's plastic handle or the side gripper to prevent the electric wire from being buried.

11. Never touch the chisel tip or parts close to the chisel tip immediately after the operation. Because it may be very hot and scald the skin

Some of the information in this article comes from the Internet and is reorganized and edited by China Rescue Equipment Network.