Power cable maintenance

The power cable is a transmission carrier used for transmission of electrical energy. It is like a bridge over which electrical energy is passed. However, this bridge is powered by electricity. The bridge must be overhauled for a long time, otherwise it will cause tragedies. For a long time, it needs to be overhauled. Otherwise, the energy leakage caused by waste of energy is small, and a safety accident is big.

Daily maintenance of the power cable is actually very simple, because the power cable is produced under the constraints of the power cable model, as long as the power cable model guidelines to repair it, you should first check the outer layer of the cable insulation, if it appears Damage, or oxidation, should be dealt with promptly to prevent further accidents, and then check the power cable connector, according to the same type of cable product purchased under the power cable model, so the connector only needs to check if there is loose phenomenon, if Loosening occurs and reinforcement must be done in a timely manner.

The transmission of electrical energy is a matter of survival. It is very important to carry out daily inspections on cables that have been laid. We must pay attention to the details of inspections. If you neglect one, you may become a disaster.

Hand Applied Wrapping Machine

The Hand Applied wrapping machine is a lightweight, low profile pipe wrapping machine that provides a simple way to apply tape coatings on pipelines. It can be used on any pipe 4" or larger and can accommodate tape with a core diameter of 1 1/2 or 3 inches. It can easily be used for either spiral or cigarette wrapping and is designed with separate tension adjustments for tape and release line take-up. This machine should be ordered by the width of the tape and not the diameter of the pipe.

Details:

· Hand Applied Wrapping Machine

· Applies tape coatings on pipelines

· Separate tension adjustments for tape and release line take-up

· Will accommodate tape with 1-1/2" or 3" core diameters

· Ideal for both spiral and cigarette wrapping

· It can be used on any pipe 4" and Larger

· Very low profile, requires less clearance

· Lightweight construction

· Easy to operate

· Order these machines by the width of your tape roll – NOT the diameter of the pipe:

· 2"-6" tape roll width

· 6"-12" tape roll width

· 12"-18" tape roll width

Weight: 10 kg per pcs

Operation: at least 2 people

Anti-corrosion Tape Wrapping Machine

Wrapping Machines, Hand Applied Wrapp Machine, Anti-corrosion Tape Wrapping Machine

Jining Xunda Pipe Coating Materials Co.,Ltd , http://www.pipe-wrap.com