Grease strength limit

Source: China Bearing Network Time: 2018-01-26

/*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';

The strength limit of grease refers to the shear stress that causes the beginning of the sample to move; also known as the ultimate shear stress or strength limit stress; referred to as the strength limit. The strength limit of the grease is indicated by the letter Ï„; the unit is Pa.
The standard method for determining the ultimate strength of grease is SH/T 0323-92; the maximum pressure at which the grease is attacked in the plastic threaded tube is measured at the experimental temperature; and the strength limit is replaced.
The strength limit of grease depends to a large extent on the type of thickener and its amount in the grease; the amount of soap increases; the strength limit also increases. The limit of grease strength is related to temperature. The higher the temperature The strength limit of the fat is more. The swaying of the grease is recognized by the typhoon. According to the strength limit at high temperature, the upper limit of the applicable temperature of the grease can be roughly clarified. In the actual use of the grease; the application of the grease strength limit The range is between 100-300 Pa. In general, the activity of grease is often estimated by the strength limit at high temperature, and it is easy to move with the similar viscosity value at low temperature.

Recommend to friends comments close window

Bearing related knowledge

High-speed fine-angle touch ball bearings should be paid attention to when installing the device
NSK bearing 5 large smooth door plastic in the use of rolling bearings (3)
Dismantling method and precautions for rolling bearings Analysis of the importance of smooth bearing bearings and the smooth effect of imported bearings

This article links to http://
Please indicate the bearing network http://

Previous:Inlay bearing Next:The oscillation that can not be ignored in the bearing

Copper Fittings approved WRAS,DVGW,SABSS,UPC,NSF61,covered EN1254-1 and ASME B16.22, copper fittings ,copper pipe fittings,copper plumbing fittings,copper capillary fittings,copper pressure fittings

Copper Fittings

copper fittings,copper pipe fittings,copper plumbing fittings,copper capillary fittings,copper pressure fittings

Taizhou Runde Company , https://www.smartfittings.com